First you should open mold, check the rubber mold integrity and clean. If the rubber mold is used, it should to glue mold especially appearance of small complex naturalspray wax (also can be sprinkled a little talcum powder), in order to out of wax;secondly should be preheated wax injection
Machine, open the pump, adjust the pressure and temperature. The wax out aftercareful examination, if a serious lack of edge, broken legs and so on, so that the waxbelongs to waste.
Wax injection, should use both hands to splint (can be made of organic glass plate or wood, aluminum etc.) rubber mold clamping in the fingers, pay attention to the distribution should make the rubber mold compression will average; plastic moldinjection nozzle alignment Grosbeak parallel propulsion, top up hands still noteGrosbeak, with feet tread lightly in injection
Wax switch and then loosen the hands, stay 1~2 seconds, the rubber mold placed a moment, then open the rubber mold (if the rubber mold bottom, should first will die bottom out, took out the wax). If it is some small flaws, it should be
To wax finishing.